CORNING EDC-02P-NH Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Kandang CORNING EDC-02P-NH. CORNING EDC-02P-NH 7 halaman. Environmental distribution center
Juga untuk CORNING EDC-02P-NH: Manual (12 halaman)

Halaman Cetak

10.

INSTALLING DROP CABLE

Step 1:

Cut subunit lengths to 51 in (130 cm).

Step 2:

Feed cable through fitting in base.

Step 3:

If no central member is present, loosely secure cable to the drop cable strain-relief bracket

with a cable tie. If there is a central member present, remove the bracket and strain-relieve

as decribed in Section 7.

Step 4:

route the cable through the radius guides/routing clips.

Step 5:

Clean and mate the connectors and adapters.

EDC-02P-NH

11.

FINALIZE INSTALLATION

Step 1:

Record fiber identification on the label in

a logical way and attach to inside of front door.

Step 2:

Secure front door with slotted screwdriver.

NOTE:

the optional Quick release Latch Kit may be installed

to facilitate access to the housing. A padlock may be

installed to prevent unauthorized access.

Corning Cable Systems LLC • PO Box 489 • Hickory, NC 28603-0489 USA

1-800-743-2671 • FAX +1-828-325-5060 • International +1-828-901-5000 • http://www.corning.com/cablesystems

Corning Cable Systems reserves the right to improve, enhance, and modify the features and specifications of Corning Cable Systems' products without prior notification. All

trademarks are the properties of their respective owners. Corning Cable Systems is ISO 9001 certified.

STANDARD RECOMMENDED PROCEDURE 003-304 | ISSUE 10 | September 2010 | PAGE 7 OF 7

EDC-06P-NH

TPA-2928

EDC-12P-NH

TPA-2929

TPA-2930

TPA-2931