CORNING EDGE Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Rak dan Dudukan CORNING EDGE. CORNING EDGE 11 halaman. Single-module housing
Juga untuk CORNING EDGE: Instalasi (4 halaman)

Halaman Cetak

3.2. To Access Interior of FZB for Cable and Module Installation

Step 1:

Remove the plates covering the cable entry locations to be used (Figure 2).

Step 2:

Remove the two packing screws next to the latches to enable the inner tray to be removed;

then lift the four latches on the inner plate. Lift the plate out of the box.

Note: The FZB may have either the EDGE™ or the EDGE8™ module trays installed.

3.3. To Remove the Door

Step 1:

Remove the hole plug and insert a screwdriver

through the hole.

Step 2:

Loosen the screw on the hinge bracket shown in

Figure 3.

Step 3:

Slide the hinge bracket out of the way.

Step 4:

Slide the door up to disengage the hinge pin.

Step 5:

Lift door off the cabinet.

STANDARD RECOMMENDED PROCEDURE 003-825-AEN | ISSUE 7 | NOVEMBER 2020 | PAGE 2 OF 11

Figure 2

Figure 3