CORNING EDGE 매뉴얼 - 페이지 2
{카테고리_이름} CORNING EDGE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING EDGE 11 페이지. Single-module housing
CORNING EDGE에 대해서도 마찬가지입니다: 설치 (4 페이지)
3.2. To Access Interior of FZB for Cable and Module Installation
Step 1:
Remove the plates covering the cable entry locations to be used (Figure 2).
Step 2:
Remove the two packing screws next to the latches to enable the inner tray to be removed;
then lift the four latches on the inner plate. Lift the plate out of the box.
Note: The FZB may have either the EDGE™ or the EDGE8™ module trays installed.
3.3. To Remove the Door
Step 1:
Remove the hole plug and insert a screwdriver
through the hole.
Step 2:
Loosen the screw on the hinge bracket shown in
Figure 3.
Step 3:
Slide the hinge bracket out of the way.
Step 4:
Slide the door up to disengage the hinge pin.
Step 5:
Lift door off the cabinet.
STANDARD RECOMMENDED PROCEDURE 003-825-AEN | ISSUE 7 | NOVEMBER 2020 | PAGE 2 OF 11
Figure 2
Figure 3