CORNING EDGE 매뉴얼 - 페이지 4

{카테고리_이름} CORNING EDGE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING EDGE 11 페이지. Single-module housing
CORNING EDGE에 대해서도 마찬가지입니다: 설치 (4 페이지)

Step 4:

Reinstall all floor tiles with the panel-lifter tool. Ensure tiles are even with adjacent tiles. If the

floor tile over the FZB will not lay flat and even, it may be necessary to install the box below

the stringers as described in Section 4.2.3.

4.2.2 Alternative Method 1

If unable to successfully install the unit under a raised floor following the instructions in Section 4.2.1:

Step 1:

Remove one of the trim plates and reinsert the housing into the center opening. Allow the

side where the trim plate was removed to drop below the stringer on that side (Figure 7).

STANDARD RECOMMENDED PROCEDURE 003-825-AEN | ISSUE 7 | NOVEMBER 2020 | PAGE 4 OF 11

Figure 6

Figure 7