CORNING EDGE 매뉴얼 - 페이지 5

{카테고리_이름} CORNING EDGE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING EDGE 11 페이지. Single-module housing
CORNING EDGE에 대해서도 마찬가지입니다: 설치 (4 페이지)

Step 2:

Position the trim plate into the gap between the stringer and the FZB. Reinstall the trim plate

to the side of the unit with the provided screws (Figure 7 inset). (It may require two people to

perform this operation.)

Step 3:

Reinstall all floor tiles with the panel-lifter tool. Ensure tiles are even with adjacent tiles. If the

floor tile over the FZB will not lay flat and even, it may be necessary to install the box below

the stringers as described in Section 4.2.3.

4.2.3 Alternative Method 2

With some raised floor systems and/or if desired, the FZB may be mounted directly to the substructure.

If there are no cables or conduit running under the FZB, the bottom of the unit will rest directly on the

substructure or concrete floor. Ensure there is enough depth for the top of the unit to be just below the

stringers.

Step 1:

Remove stringers, lower FZB into the opening below the level of the stringers, and reinstall

the stringers.

Step 2:

Reinstall all floor tiles with the panel-lifter tool. Ensure tiles are even with adjacent tiles.

4.3. In a Suspended Ceiling

In a suspended ceiling, the door of the FZB can replace the tile for optimal accessibility. To do so, a

ceiling trim plate kit ((p/n FZB-04U-CLG, ordered separately) must be installed onto the FZB.

NOTE:

Mounting hardware and supports are not included. Use framing members (threaded rod in

conjunction with metal struts) or support wires compliant with NEC Article 314.23 D (Supports for

Suspending Ceilings). Support wires must be capable of supporting a fully loaded FZB (maximum

50 lb.).

Step 1:

Install (4) supplied wallmount brackets to

the FZB using the provided screws.

Step 2:

Install ceiling trim plate kit ((p/n FZB-04U

CLG) as shown in Figure 8.

STANDARD RECOMMENDED PROCEDURE 003-825-AEN | ISSUE 7 | NOVEMBER 2020 | PAGE 5 OF 11

Figure 8