Makita 6924N Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita 6924N. Makita 6924N 8 halaman. Shear wrench
Juga untuk Makita 6924N: Buku Petunjuk (20 halaman), Buku Petunjuk (8 halaman)

Halaman Cetak

005848

CAUTION:

Replace nut, bolt and washer all together at one

•

time when these rotate together, nut rotates

excessively or a bolt protrude from nut surface too

much or less.

Do not reuse used nut, bolt and washer.

•

Choose shear bolts according to the thickness of

•

workpiece to be fastened. Range for the remaining

length of bolts that are obtained after cutting off

chips are determined by bolt size. Refer to the

table below for details.

Maximum

Bolt size

remainig

length

M22

26mm

M24

23mm

007540

007539

CAUTION:

Use bolts with the remaining length within the

•

range shown in the table above as bolts with

different

size

have

minimum remaining length. Be careful not to use

bolts beyond the specified range which causes the

tool damage

1. Identification

mark

2. Nut

3. Bolt

4. Chamfered

5. Washer

Minimum

remainig

length

7mm

10mm

1. Remaining

length

different

maximum

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

005849

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be

performed by Makita Authorized Service Centers,

always using Makita replacement parts.

ACCESSORIES

CAUTION:

These

•

recommended for use with your Makita tool

and

specified in this manual. The use of any other

accessories or attachments might present a risk of

injury to

attachment for its stated purpose.

If you need any assistance for more details regarding

these accessories, ask your local Makita Service Center.

1. Limit mark

1. Screwdriver

2. Brush holder

accessories

attachments

persons.

Only use

cap

are

accessory or