Makita 6924N Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita 6924N. Makita 6924N 8 страниц. Shear wrench
Также для Makita 6924N: Руководство по эксплуатации (20 страниц), Руководство по эксплуатации (8 страниц)
Печатать страницу
1
2
005848
CAUTION:
Replace nut, bolt and washer all together at one
•
time when these rotate together, nut rotates
excessively or a bolt protrude from nut surface too
much or less.
Do not reuse used nut, bolt and washer.
•
Choose shear bolts according to the thickness of
•
workpiece to be fastened. Range for the remaining
length of bolts that are obtained after cutting off
chips are determined by bolt size. Refer to the
table below for details.
Maximum
Bolt size
remainig
length
M22
26mm
M24
23mm
007540
1
007539
CAUTION:
Use bolts with the remaining length within the
•
range shown in the table above as bolts with
different
size
have
minimum remaining length. Be careful not to use
bolts beyond the specified range which causes the
tool damage
1. Identification
mark
3
2. Nut
3. Bolt
4
4. Chamfered
5. Washer
5
Minimum
remainig
length
7mm
10mm
1. Remaining
length
different
maximum
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
2
1
005849
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
•
recommended for use with your Makita tool
and
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
6
1. Limit mark
1
1. Screwdriver
2. Brush holder
accessories
or
attachments
persons.
Only use
cap
are
accessory or