Makita BJS100 Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Makita BJS100. Makita BJS100 12 halaman. Cordless metal shears 1.0mm (20ga)
Juga untuk Makita BJS100: Buku Petunjuk (8 halaman), Informasi Teknis (9 halaman)

Halaman Cetak

010086

Then use the hex wrench to adjust the clearance by

tightening or loosening the bolt. There may be a slight

difference between clearance of both sides of the center

blade.

Check the smaller clearance with the thickness gauge

and adjust it.

When using the thickness gauge to adjust the blade

clearance, refer to the table.

Workpiece thickness (mm)

Less than 0.8

0.8 - 1.3

More than 1.3

006428

After adjusting the clearance, tighten the screw securely.

Storing hex wrench

010087

Store the hex wrench as shown in the figure when not in use.

OPERATION

Lubrication

010084

Before operation, lubricate the contact point of the center

blade and the pin. To keep good cutting performance,

also use a cutting lubricant from time to time during

operation.

1. Center blade

2. Thickness gauge

3. Side blade

4. Hex wrench

5. Hex socket head

bolt

Marking on thickness gauge

0.5

1.0

1.5

1. Hex wrench

1. Oil supply

2. Center blade

3. Pin

OPERATION

010090

Turn the tool on and set front ends of the side blades on

the workpiece. Now simply move the tool forward,

keeping the side blades flush with the workpiece surface.

010091

CAUTION:

When cutting a small portion of the workpiece, you

•

may have difficulty completing the end of the cut. In

that case, try to cut it again, pulling the workpiece

back slightly.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before attempting to

perform inspection or maintenance.

NOTICE:

Never use gasoline, benzine, thinner, alcohol or the

•

like. Discoloration, deformation or cracks may

result.

The tool and its air vents have to be kept clean. Regularly

clean the tool's air vents or whenever the vents start to

become obstructed.

Replacing carbon brushes

001145

1. Limit mark