KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range Panduan Petunjuk Instalasi - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Rentang KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range. KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range 16 halaman. 30" (76.2 cm) and 36" (91.4 cm) classic commercial-style dual fuel convection range with steam-assist

Halaman Cetak
3-Wire Cable from Power Supply
IMPORTANT: Use the 3-wire cable from power supply where
local codes permit connecting the frame-ground conductor to
the neutral (white) junction box wire.
A
B
C
D
E
F
A. Cable from power supply
B. Junction box
C. Red wires
D. White wire (from power supply)
E. White and green (or bare) grounding
wires (from range) - factory crimped
1. Disconnect power.
2. Remove junction box cover if present.
3. Connect the flexible armored cable from the range to the
junction box using a UL listed or CSA approved conduit
connector.
4. Tighten screws on conduit connector if present.
5. Connect the two black wires together using UL listed wire
nuts.
6. Connect the two red wires together using UL listed wire nuts.
7. Connect the factory-crimped bare and white range cable
wires to the white (neutral) wire in the junction box using UL
listed wire nuts.
8. Install junction box cover.
9. Reconnect power.

Attach Backguard or Island Trim

WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Using 2 or more people, move range close to cabinet
opening.
2. Remove cardboard or hardboard from under range. Move
range into final position.
3. Attach the backguard or island trim as required for your
installation. See "Tools and Parts." Attachment screws are
included in the literature package.
G
H
I
F. 4-wire cable from range
G. Black wires
H. UL listed wire nuts
I. UL listed or CSA approved
conduit connector
Attaching the Backguard
36" model shown
A. 3 front screws (4 rear screws required but not shown)
Attaching the Island Trim
36" model shown
A. Center hole not used
4. Using 2 or more people, tip the range back so that the front
feet lift off the ground. Slide range toward the wall until the
rear brace is under the anti-tip bracket. Stand range up,
making sure the anti-tip bracket catches the rear brace.

Make Gas Connection

1. Assemble flexible connector from gas supply pipe to pressure
regulator located in the middle front of the range.
2. Apply pipe-joint compound made for use with LP gas to the
smaller thread ends of the flexible connector adapters (see B
and G in following illustration).
3. Attach one adapter to the gas pressure regulator and the
other adapter to the gas shutoff valve. Tighten both adapters.
4. Use a
" combination wrench and channel lock pliers to
attach the flexible connector to the adapters. Check that
connector is not kinked.
A
B C
A. Gas pressure regulator
B. Use pipe-joint compound
C. Adapter (must have ½" male
pipe thread)
D. Flexible connector
A
A
D
E
H
G
F
E. Manual gas shutoff valve
F. ½" or ¾" gas pipe
G. Use pipe-joint compound
H. Adapter
11