KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range Installation Instructions Manual - Page 11

Browse online or download pdf Installation Instructions Manual for Ranges KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range. KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range 16 pages. 30" (76.2 cm) and 36" (91.4 cm) classic commercial-style dual fuel convection range with steam-assist

Print Page

3-Wire Cable from Power Supply

IMPORTANT: Use the 3-wire cable from power supply where

local codes permit connecting the frame-ground conductor to

the neutral (white) junction box wire.

A. Cable from power supply

B. Junction box

C. Red wires

D. White wire (from power supply)

E. White and green (or bare) grounding

wires (from range) - factory crimped

1. Disconnect power.

2. Remove junction box cover if present.

3. Connect the flexible armored cable from the range to the

junction box using a UL listed or CSA approved conduit

connector.

4. Tighten screws on conduit connector if present.

5. Connect the two black wires together using UL listed wire

nuts.

6. Connect the two red wires together using UL listed wire nuts.

7. Connect the factory-crimped bare and white range cable

wires to the white (neutral) wire in the junction box using UL

listed wire nuts.

8. Install junction box cover.

9. Reconnect power.

Attach Backguard or Island Trim

WARNING

Excessive Weight Hazard

Use two or more people to move and install range.

Failure to do so can result in back or other injury.

1. Using 2 or more people, move range close to cabinet

opening.

2. Remove cardboard or hardboard from under range. Move

range into final position.

3. Attach the backguard or island trim as required for your

installation. See "Tools and Parts." Attachment screws are

included in the literature package.

F. 4-wire cable from range

G. Black wires

H. UL listed wire nuts

I. UL listed or CSA approved

conduit connector

Attaching the Backguard

36" model shown

A. 3 front screws (4 rear screws required but not shown)

Attaching the Island Trim

36" model shown

A. Center hole not used

4. Using 2 or more people, tip the range back so that the front

feet lift off the ground. Slide range toward the wall until the

rear brace is under the anti-tip bracket. Stand range up,

making sure the anti-tip bracket catches the rear brace.

Make Gas Connection

1. Assemble flexible connector from gas supply pipe to pressure

regulator located in the middle front of the range.

2. Apply pipe-joint compound made for use with LP gas to the

smaller thread ends of the flexible connector adapters (see B

and G in following illustration).

3. Attach one adapter to the gas pressure regulator and the

other adapter to the gas shutoff valve. Tighten both adapters.

4. Use a

" combination wrench and channel lock pliers to

attach the flexible connector to the adapters. Check that

connector is not kinked.

B C

A. Gas pressure regulator

B. Use pipe-joint compound

C. Adapter (must have ½" male

pipe thread)

D. Flexible connector

E. Manual gas shutoff valve

F. ½" or ¾" gas pipe

G. Use pipe-joint compound

H. Adapter