Makita DCO180 Informasi Teknis - Halaman 7
Jelajahi secara online atau unduh pdf Informasi Teknis untuk Alat Listrik Makita DCO180. Makita DCO180 8 halaman. Cordless cut-out tool
Juga untuk Makita DCO180: Buku Petunjuk (13 halaman), Buku Petunjuk (13 halaman)
Halaman Cetak
C
ircuit diagram
Fig. D-1
Receptacles
Terminal
black
How to Check the Switch Condition
1. Unscrew the two screws or disconnect the two receptacles.
(If not, the Switch condition cannot be judged correctly because current flows through Controller.)
2. Check the condition between the terminals (shown below) with a tester (Makita part No. 1R402).
Good condition
Terminals
Switch condition
OFF
ON
• Either of the two red lead wires from Terminal and
Controller can be connected to either 1 or 2 .
• Either of the two red lead wires from Terminal and
Controller can be connected to either
red
red
red
red
yellow
Controller
and
and
∞ )
∞ )
O.L (
O.L (
Ω or less
Ω or less
0.1
0.1
Switch
Pan head screws
Insulated terminals
red
black
or
.
Endbell complete
viewed from rear side
red
Line filter
(if used)
Connectors
P 7/ 8