Makita DCO180 Informacje techniczne - Strona 7
Przeglądaj online lub pobierz pdf Informacje techniczne dla Elektronarzędzie Makita DCO180. Makita DCO180 8 stron. Cordless cut-out tool
Również dla Makita DCO180: Instrukcja obsługi (13 strony), Instrukcja obsługi (13 strony)
Drukuj stronę
C
ircuit diagram
Fig. D-1
Receptacles
Terminal
black
How to Check the Switch Condition
1. Unscrew the two screws or disconnect the two receptacles.
(If not, the Switch condition cannot be judged correctly because current flows through Controller.)
2. Check the condition between the terminals (shown below) with a tester (Makita part No. 1R402).
Good condition
Terminals
Switch condition
OFF
ON
• Either of the two red lead wires from Terminal and
Controller can be connected to either 1 or 2 .
• Either of the two red lead wires from Terminal and
Controller can be connected to either
red
red
red
red
yellow
Controller
and
and
∞ )
∞ )
O.L (
O.L (
Ω or less
Ω or less
0.1
0.1
Switch
Pan head screws
Insulated terminals
red
black
or
.
Endbell complete
viewed from rear side
red
Line filter
(if used)
Connectors
P 7/ 8