AIRFUN 12525 Panduan Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Produk Perawatan Pribadi AIRFUN 12525. AIRFUN 12525 8 halaman. Portable chair for recovery
Halaman Cetak
3.
SAFETY INSTRUCTIONS
3.1. General instructions:
•
The product is meant to be set-up by competent personnel.
•
Before each usage check the pressure of the chair and inflate it to full.
•
Use a clean chair cover for every individual, in order to guarantee a hygienic use.
3.2. Recovery chair handling:
•
The area on which the chair is placed must be clean, dry, flat and free of obstacles.
•
Do not wear shoes while recovering on the chair, as they may damage the surface.
•
Do not bring any sharp items on or close to the chair.
•
The maximum weight load of 200 kg should not be exceeded.
•
Always set up the chair in the same area, where you will be using it. When changing
the location, do not drag the chair over the surface, but carry it.
•
When setting up the chair outdoor, use a groundsheet to avoid damaging the product.
•
Never pack, store or transport the Recovery chair, when it is wet or dirty. After cleaning,
to prevent damages, allow material to dry properly before usage or storage.
•
Never leave the chair outside unattended and keep the air pressure under the maximum
values, described in this guide.
•
Do not expose inflated chair to extreme temperature conditions
(allowed limit from -20°C to +50°C).
3.3 Inflation process:
•
Prior to connection of electric pump to mains supply, check that the voltage stated
on the plate correspond with the available mains supply.
•
Prior to start inflating, check that the safety valve is closed.
Safety valve is designed to release excess pressure from the chair, if such situation occur, like
huge temperature changes or not using original pump, when inflating (higher pressure), etc.
•
Do not use the electric pump in humid environments or close to water, also never touch
the power cable with wet hands (risk of electric shock).
•
After inflating / deflating the chair, switch off the blower immediately to avoid overheating
the motor.
•
Do not inflate beyond max. air pressure, stated in technical data. This cannot happen, when
using original electric pump, supplied by Airfun d.o.o.
•
While inflating make sure that any kind of dust or sand do not enter into the pneumatic insert.