GARDEN SECRETS GS-503 Instruksi Pengguna

Jelajahi secara online atau unduh pdf Instruksi Pengguna untuk Peralatan Rumput dan Taman GARDEN SECRETS GS-503. GARDEN SECRETS GS-503 2 halaman. Solar powered mole & snake repellent
Juga untuk GARDEN SECRETS GS-503: Instruksi Pengguna (2 halaman)

Halaman Cetak

Solar Powered Mole & Snake Repellent GS-503

Thanks for your purchasing our device. Please read and understand these instructions and keep

this manual for future reference.

The solar mole and snake repeller unit is designed to repel moles and snakes, by emitting a pulse

which moles and snakes feel as a vibration transmitted through the ground. Moles and Snakes

then perceive a danger zone causing them to evacuate the area, not so much a physical barrier,

but rather creating an area where the snakes do not want to be.

Operation

The repeller transmits its signal in all directions approx. 10ft (3m), they can be placed

approx. 20ft (6m) apart to get optimum coverage, it is always recommended to use two or

more units to get the best results. Place a unit close to retaining walls, rock gardens, old

sheds etc. to drive snakes out from their hiding places and away. When first installing the

units, keep children and animals away from the area for the first hour in case any snakes

are driven out of their hiding places.

The unit works with rechargeable batteries. The solar module runs the unit and charges

the battery during the day night-time operation is enabled by the batteries.

Installation procedure

1. Press "ON" under the head of the unit, attach the small connectors on the

wires from the base of the head of the unit to the one from the spike section,

and attach the spike to the head of the unit. (The stick and the head should

be attached tightly, but not too much, to have contact with the wires inside

the stick).

2. Insert the spike into the ground paying attention not to damage the unit. The

spike should be firmly planted while leaving the base of the head minimum

1-2" above the ground. We suggest use a crowbar to first make a small hole

and gently push the spike in or dig a small hole and backfill with earth after

the unit is in place. Do not use a mallet, hammer or excessive force as this may

damage the unit. As long as you can get the unit 2/3 rds of the way into the

ground with firm ground contact, is good.

3. You can tell the unit is operating, as its led light will flash as it transmits its

signal, you will feel the vibrations.

4. Sometimes the unit may need a short time in the sun to give them a boost and

start up, when first installed. If the unit stops operating check/change the

battery to see that it is OK – as this is the usual reason for the units to stop

operating.

USER INSTRUCTION