GARDEN SECRETS GS-503 Instruksi Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Instruksi Pengguna untuk Peralatan Rumput dan Taman GARDEN SECRETS GS-503. GARDEN SECRETS GS-503 2 halaman. Solar powered mole & snake repellent
Juga untuk GARDEN SECRETS GS-503: Instruksi Pengguna (2 halaman)

Halaman Cetak

Weather

Although the units are weatherproof, it is recommended that you remove it under extreme

weather conditions such as hail, flooding and snow. If the unit does become waterlogged

and the unit ceases to work, take it out and leave to dry, normally when completely dry the

unit will return to normal operation. Normally the only maintenance required is with a soft

cloth; wipe the solar panel cover to remove any excess dirt and grime.

Please take care when removing the units from the ground, that you do not break them.

Battery Replacement

After some time the batteries may start to loose efficiency, these can be replaced by two

AA size rechargeable NiMh 1.2V batteries are recommended. Battery compartment is

located in the underside of the head section.

While the unit should reduce the

number of snakes around your

home when installed and working,

you should always be vigilant,

nothing can be 100% effective as

unforeseen

circumstances

may

occur and this may result in the

chance of an occasional snake not

being immediately repelled, and

although probably leaving the area

there is no control over what

direction any snakes will take to get

away. Some snakes may initially

retreat up off the ground /or on to

concrete areas etc. until they

decide where to go. Other external

factors such as heavy equipment operating close by may temporarily influence the

effectiveness of the units.

Prevent animals from getting used to it

Occasionally snakes and moles that are resident close by may become accustomed to the

units and slowly come closer to the protected area, if you think this is happening, it is a

good idea to relocate the units – by moving them 3-4 yards every 2-3 months should be

enough to prevent this.

Technical faults

If you have a technical issue, please scan

the code to resolve the problem: