GARDEN SECRETS GS-503 사용자 지침 - 페이지 2

{카테고리_이름} GARDEN SECRETS GS-503에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. GARDEN SECRETS GS-503 2 페이지. Solar powered mole & snake repellent
GARDEN SECRETS GS-503에 대해서도 마찬가지입니다: 사용자 지침 (2 페이지)

페이지 인쇄

Weather

Although the units are weatherproof, it is recommended that you remove it under extreme

weather conditions such as hail, flooding and snow. If the unit does become waterlogged

and the unit ceases to work, take it out and leave to dry, normally when completely dry the

unit will return to normal operation. Normally the only maintenance required is with a soft

cloth; wipe the solar panel cover to remove any excess dirt and grime.

Please take care when removing the units from the ground, that you do not break them.

Battery Replacement

After some time the batteries may start to loose efficiency, these can be replaced by two

AA size rechargeable NiMh 1.2V batteries are recommended. Battery compartment is

located in the underside of the head section.

While the unit should reduce the

number of snakes around your

home when installed and working,

you should always be vigilant,

nothing can be 100% effective as

unforeseen

circumstances

may

occur and this may result in the

chance of an occasional snake not

being immediately repelled, and

although probably leaving the area

there is no control over what

direction any snakes will take to get

away. Some snakes may initially

retreat up off the ground /or on to

concrete areas etc. until they

decide where to go. Other external

factors such as heavy equipment operating close by may temporarily influence the

effectiveness of the units.

Prevent animals from getting used to it

Occasionally snakes and moles that are resident close by may become accustomed to the

units and slowly come closer to the protected area, if you think this is happening, it is a

good idea to relocate the units – by moving them 3-4 yards every 2-3 months should be

enough to prevent this.

Technical faults

If you have a technical issue, please scan

the code to resolve the problem: