GARDEN SECRETS GS-503 Instructions pour l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} GARDEN SECRETS GS-503. GARDEN SECRETS GS-503 2 pages. Solar powered mole & snake repellent
Également pour GARDEN SECRETS GS-503 : Instructions pour l'utilisateur (2 pages)

Weather
Although the units are weatherproof, it is recommended that you remove it under extreme
weather conditions such as hail, flooding and snow. If the unit does become waterlogged
and the unit ceases to work, take it out and leave to dry, normally when completely dry the
unit will return to normal operation. Normally the only maintenance required is with a soft
cloth; wipe the solar panel cover to remove any excess dirt and grime.
Please take care when removing the units from the ground, that you do not break them.
Battery Replacement
:
After some time the batteries may start to loose efficiency, these can be replaced by two
AA size rechargeable NiMh 1.2V batteries are recommended. Battery compartment is
located in the underside of the head section.
While the unit should reduce the
number of snakes around your
home when installed and working,
you should always be vigilant,
nothing can be 100% effective as
unforeseen
circumstances
may
occur and this may result in the
chance of an occasional snake not
being immediately repelled, and
although probably leaving the area
there is no control over what
direction any snakes will take to get
away. Some snakes may initially
retreat up off the ground /or on to
concrete areas etc. until they
decide where to go. Other external
factors such as heavy equipment operating close by may temporarily influence the
effectiveness of the units.
Prevent animals from getting used to it
Occasionally snakes and moles that are resident close by may become accustomed to the
units and slowly come closer to the protected area, if you think this is happening, it is a
good idea to relocate the units – by moving them 3-4 yards every 2-3 months should be
enough to prevent this.
Technical faults
If you have a technical issue, please scan
the code to resolve the problem: