Gardena classicCut special Panduan Petunjuk Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemangkas Gardena classicCut special. Gardena classicCut special 13 halaman. Turbotrimmer
Halaman Cetak
F
G
H
3
K
J
6. Trouble-Shooting
Risk of injury !
Pulling the filament
out of the filament cassette :
H
I
3
14
1. Unplug the mains plug.
2. Turn over the Turbotrimmer and rest it on the rubber buffer
of the handle.
G
3. Release the cassette cover
and remove the cover.
4. Remove the filament cassette
5. Remove any dirt.
6. Pull approximately 5 cm of the filament
I
filament cassette
7. Insert the filament cassette
so that the filament
8. Fit the cassette cover
that you hear both locking clips
When replacing the cover, ensure that the filament is inside the
metal case and is not trapped.
v If the cassette cover
filament cassette
is completely in the filament cassette holder
Risk of injury from the cutting filament !
V Always unplug the mains plug of the Turbotrimmer be-
fore troubleshooting.
You can pull the filament out of the filament cassette if the filament
is too short or if it is drawn inside the cassette.
1. Unplug the mains plug.
2. Remove the filament cassette as described under 5. Mainte-
nance "Replacing the filament cassette" .
3. Press together the plastic ring
between your thumb and forefinger.
4. Draw the plastic ring
the side part of the filament cassette
if necessary).
You can now access the filament that was drawn into the
filament cassette.
5. Unwind the filament
it through the eye of the plastic ring
sary, loosen the filament beforehand using
a screwdriver. The filament
out max. 2 cm over the knife
6. Pull the plastic ring
filament cassette
7. Reinstall the filament cassette as described
under 5. Maintenance "Replacing the
I
filament cassette".
F
by pressing both locking clips
H
.
3
H
through the eye of the plastic ring
H
in the filament cassette holder
3
is inside the metal case
F
on the filament cassette holder
G
click into place.
F
cannot be touched down, turn the
H
to and fro, until the filament cassette
I
on the filament cassette
I
with the thumb of the other hand over
H
3
approximately 10 cm and thread
I
. If neces-
3
may stand
L
.
I
back over the
H
.
G
out of the new
I
.
J
K
.
J
so
H
J
.
H
(use a screwdriver
L