Gardena classicCut special Panduan Petunjuk Pengoperasian - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemangkas Gardena classicCut special. Gardena classicCut special 13 halaman. Turbotrimmer
Halaman Cetak
Cleaning the filament cassette
and area around the filament
cassette :
H
3
J
Fault
The Turbotrimmer
no longer cuts.
If you have any other problems please contact the GARDENA Customer Service.
7. Storage
Storage :
Disposal :
(in accordance with
RL 2002 / 96 / EC)
If the automatic filament feed still does not work after pulling
the filament out of the filament cassette, the filament cassette
and area around the filament cassette may be dirty.
1. Remove the plastic ring
filament cassette
under "Pulling the filament out of the
filament cassette".
2. Unwind the filament
filament cassette and the filament
I
then wind the filament back onto
the cassette.
3. Clean the automatic mechanism
M
lever
in the filament cassette
J
holder
.
The automatic mechanism lever must move freely.
4. Reinstall the filament cassette as described under "Pulling
the filament out of the filament cassette".
Only GARDENA Service Centres and authorised specialist
GARDENA dealers may carry out repairs.
Possible cause
Filament cassette empty.
Filament too short, drawn into
the cassette or stuck together.
Automatic filament feed is not
working since the automatic
mechanism lever is jammed.
The Turbotrimmer must be stored out of the reach of children.
v Store your Turbotrimmer in a dry place where it is protected
from frost.
Recommended storage :
We recommend that you hang your Turbotrimmer from the cable
lock. Hanging storage helps avoid unnecessary stress on the
cutting head.
The product must not be added to normal household waste. It
must be disposed of in line with local environmental regulations.
v Important: Make sure that the unit is disposed of via your
municipal recycling collection centre.
I
from the
H
as described
3
, clean the
Remedy
v Replace the filament cassette
– see 5. Maintenance
"Replacing the filament
cassette" ).
v Pull the filament out of the
filament cassette (see above).
v Clean the filament cassette
and area around the
cassette (see above).
M
J
15