Gardena 1407 Panduan Petunjuk Pengoperasian - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Rumput dan Taman Gardena 1407. Gardena 1407 11 halaman. Flower box watering set
Juga untuk Gardena 1407: Panduan Petunjuk Pengoperasian (12 halaman), Panduan Petunjuk Pengoperasian (11 halaman), Panduan Operator (13 halaman), Panduan Petunjuk Pengoperasian (12 halaman), Panduan Petunjuk Pengoperasian (11 halaman)
Halaman Cetak
7.3 Sensor Operation
By selecting programs 1 - 13
when the GARDENA Soil Mois-
ture Sensor (Art. No. 1188) is con-
nected, timer-controlled watering
is prevented or interrupted if the
soil is sufficiently moist.
8. Maintenance, care, storage
Attention ! Disconnect
A
the mains plug before
carrying out any work on the
system !
Cleaning the filter (fig. F)
The pump is almost maintenance-
free.
It has an integrated filter which
needs to be cleaned in the follow-
ing way, after the system has
been shut-off :
1. Press both orange locking
A
knobs
and remove the
base of the pump (fig. F).
9. Faults
Fault
Pump does not run.
No water is delivered.
The watering cycles are
incorrect.
The system still runs after the
pump has been turned off.
14
Alternatively, by connecting the
GARDENA Rain Sensor (Art. No.
1189) watering can be prevented
or interrupted if it starts to rain.
By selecting automatic program
14, watering can be switched on
and off completely automatically
depending on the moisture level
0
2. Take out the filter
rinse in clean water.
3. Replace the filter into the
suction base.
4. Re-connect the base to
the pump. Ensure that locking
knobs snap firmly into posi-
tion.
Attention ! The housing
A
of the pump is sealed at
the thread. Any work on elec-
trical parts must only be carried
out by GARDENA Service.
Possible cause
Mains connector or pump
connector are not plugged in.
Soil Moisture Sensor / Rain
Sensor indicates moisture.
Container is empty.
0
The pump filter
is blocked.
The adjustment knob
the transformer is set in between
programmes.
Inline Drip Heads are installed
lower than water level in con-
tainer.
of the soil. You must connect the
GARDENA Soil Moisture Sensor
(Art. No. 1188) (see also the notes
in the Soil Moisture Sensor oper-
ating instructions).
and
In frost affected areas the pump
and transformer must be stored
in a dry place.
Device may not be added to nor-
mal household refuse but must
be disposed of in the technically
correct way.
Remedy
Insert the mains plug in the outlet
socket, or the pump connector
plug in the socket at the trans-
former.
Wait until the Soil Moisture
Sensor / Rain Sensor has dried
out sufficiently.
Fill container with water.
Clean the pump filter
(section 8.1).
9
of
Set the adjustment knob exactly
onto desired position.
Choose another location for the
container, where the water level
is below the Inline Drip Heads.
Install an Inline Drip Head to vent
the system.
G
Disposal :
(in accordance with
Directive 2012 / 19 / EU)