Gardena 1407 사용 설명서 - 페이지 7

{카테고리_이름} Gardena 1407에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 1407 11 페이지. Flower box watering set
Gardena 1407에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지), 사용 설명서 (11 페이지), 운영자 매뉴얼 (13 페이지), 사용 설명서 (12 페이지), 사용 설명서 (11 페이지)

페이지 인쇄

7.3 Sensor Operation

By selecting programs 1 - 13

when the GARDENA Soil Mois-

ture Sensor (Art. No. 1188) is con-

nected, timer-controlled watering

is prevented or interrupted if the

soil is sufficiently moist.

8. Maintenance, care, storage

Attention ! Disconnect

the mains plug before

carrying out any work on the

system !

Cleaning the filter (fig. F)

The pump is almost maintenance-

free.

It has an integrated filter which

needs to be cleaned in the follow-

ing way, after the system has

been shut-off :

1. Press both orange locking

knobs

and remove the

base of the pump (fig. F).

9. Faults

Fault

Pump does not run.

No water is delivered.

The watering cycles are

incorrect.

The system still runs after the

pump has been turned off.

Alternatively, by connecting the

GARDENA Rain Sensor (Art. No.

1189) watering can be prevented

or interrupted if it starts to rain.

By selecting automatic program

14, watering can be switched on

and off completely automatically

depending on the moisture level

2. Take out the filter

rinse in clean water.

3. Replace the filter into the

suction base.

4. Re-connect the base to

the pump. Ensure that locking

knobs snap firmly into posi-

tion.

Attention ! The housing

of the pump is sealed at

the thread. Any work on elec-

trical parts must only be carried

out by GARDENA Service.

Possible cause

Mains connector or pump

connector are not plugged in.

Soil Moisture Sensor / Rain

Sensor indicates moisture.

Container is empty.

The pump filter

is blocked.

The adjustment knob

the transformer is set in between

programmes.

Inline Drip Heads are installed

lower than water level in con-

tainer.

of the soil. You must connect the

GARDENA Soil Moisture Sensor

(Art. No. 1188) (see also the notes

in the Soil Moisture Sensor oper-

ating instructions).

and

In frost affected areas the pump

and transformer must be stored

in a dry place.

Device may not be added to nor-

mal household refuse but must

be disposed of in the technically

correct way.

Remedy

Insert the mains plug in the outlet

socket, or the pump connector

plug in the socket at the trans-

former.

Wait until the Soil Moisture

Sensor / Rain Sensor has dried

out sufficiently.

Fill container with water.

Clean the pump filter

(section 8.1).

Set the adjustment knob exactly

onto desired position.

Choose another location for the

container, where the water level

is below the Inline Drip Heads.

Install an Inline Drip Head to vent

the system.

Disposal :

(in accordance with

Directive 2012 / 19 / EU)