Fronius KD Supply 2500 Panduan Petunjuk Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem Pengelasan Fronius KD Supply 2500. Fronius KD Supply 2500 16 halaman.
Juga untuk Fronius KD Supply 2500: Panduan Petunjuk Pengoperasian (20 halaman)
Halaman Cetak
Fitting the KD Supply 2500 to the trolley
General remarks
The welding system can be fitted to a trolley to increase the mobility of the system.
IMPORTANT!
If the welding system is not equipped with an auto-transformer or a cooling unit,
the KD Supply 2500 must be installed right at the bottom.
-
Fitting the KD
Supply 2500 to
the base of the
trolley
8
If a cooling unit is present, fit it right at the bottom and place the KD Supply on top of
it.
If there are no fastening brackets on
1
the trolley:
Attach two fastening brackets to the
base of the trolley and secure each
one using three „Extrude-Tite" screws.
Place the KD Supply 2500 on the
2
base of the trolley.
Using „Extrude-Tite" screws, fasten
3
the KD Supply 2500 at the front and
back to the fastening brackets on the
base of the trolley.