- ページ 8
溶接システム Fronius KD Supply 2500のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Fronius KD Supply 2500 16 ページ。
Fronius KD Supply 2500 にも： 取扱説明書 (20 ページ)
ページを印刷する
Fitting the KD Supply 2500 to the trolley
General remarks
The welding system can be fitted to a trolley to increase the mobility of the system.
IMPORTANT!
If the welding system is not equipped with an auto-transformer or a cooling unit,
the KD Supply 2500 must be installed right at the bottom.
-
Fitting the KD
Supply 2500 to
the base of the
trolley
8
If a cooling unit is present, fit it right at the bottom and place the KD Supply on top of
it.
If there are no fastening brackets on
1
the trolley:
Attach two fastening brackets to the
base of the trolley and secure each
one using three „Extrude-Tite" screws.
Place the KD Supply 2500 on the
2
base of the trolley.
Using „Extrude-Tite" screws, fasten
3
the KD Supply 2500 at the front and
back to the fastening brackets on the
base of the trolley.