Gardena T 1030 Panduan Petunjuk Pengoperasian - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Rumput dan Taman Gardena T 1030. Gardena T 1030 18 halaman. Water timer electronic
Juga untuk Gardena T 1030: Panduan Petunjuk Pengoperasian (20 halaman), Panduan Petunjuk Pengoperasian (11 halaman), Petunjuk Pengoperasian (20 halaman), Panduan Petunjuk Pengoperasian (20 halaman)

6. Trouble-Shooting

Fault

Red LED is illuminated

for 5 seconds

(reading error)

Both LEDs are flashing

(Opening manually impossible)

Watering has not been

initiated

Battery flat after working

for a short time

If you have any other problems with your Water Timer, please contact GARDENA Service.

Possible cause

Programming card has been re-

moved too fast or too slowly when

reading in the programming data.

Dirty or wet programming card.

Slide on the programming card is v Engage the slide on the

not in an unambiguous position.

Battery level is too low.

Valve is blocked.

Water tap off.

Sensor active (shows there

is sufficient moisture).

Alkaline batteries were

not used.

Remedy

v Remove the programming

card at a constant speed.

v Clean / dry programming

card.

programming card.

v Insert new alkaline batteries.

1. Remove batteries.

2. Remove blockage and

clean filter.

v Turn tap on.

v See instructions for

the sensor.

v Use alkaline batteries.