Makita 601DST Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 601DST. Makita 601DST 15 halaman. 10 mm (3/8") battery-powered driver dril

14.

REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking t o

see that keys and adjusting wrenches are removed from tool before turning

on.

15. AVOID UNINTENTIONAL STARTING. Don't carry tool

with

finger on switch.

Be sure switch is OFF when plugging in.

16. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only

extension cords intended for use outdoors and

marked.

17. STAY ALERT. Watch what you are doing, use common sense. Don't operate

tool when you are tired.

18. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other

part that is damaged should be carefully checked t o determine that it will

operate properly and perform its intended function. Check for alignment of

moving parts, binding of moving parts, breakage of parts, mounting, and any

other conditions that may affect its operation. A guard or other part that

is damaged should be properly repaired or replaced by an authorized serv-

ice center unless otherwise indicated elsewhere in this instruction manual.

Have defective switches replaced by authorized service center. Don't use

tool

switch does not turn

on and off.

19.

GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded

surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.

20. REPLACEMENT PARTS. When servicing, use only identical replacement parts.

21, POLARIZED PLUGS. To reduce the risk of electric shock, this equipment has

a polarized plug (one blade is wider than the other). This plug

will

f i t in a

polarized outlet only one way. If the plug does not fit fully in the outlet,

reverse the plug. If it still does not fit, contact a qualified electrician t o install

the proper outlet.

not change the plug in any way.

VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,

outlet, etc.) be sure the voltage supplied is the same as that specified on the

nameplate of the tool. A power source with voltage greater than that specified

for the tool can result in SERIOUS INJURY t o the user

as well as damage t o

the tool. If in doubt,

NOT PLUG IN THE TOOL. Using a power source with

voltage less than the nameplate rating is harmful t o the motor.