Makita 6303 Buku Petunjuk - Halaman 4
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 6303. Makita 6303 8 halaman. 13mm (1/2") drill
Juga untuk Makita 6303: Buku Petunjuk (8 halaman), Buku Petunjuk (8 halaman)
Halaman Cetak
ADDITIONAL SAFETY RULES
1.
Always be sure you have a firm footing.
2. Hold the tool firmly.
3.
Keep hands away from rotating parts.
4.
When drilling into walls, floors or wherever "live" electrical wires may be
encountered,
DO
NOT TOUCH ANY METAL PARTS OF THE TOOL!
Hold the tool by the insulated grasping surfaces t o prevent electric shock if
you drill into a "live" wire.
Be sure no one is below when using the tool in high locations.
5. Do
not leave the tool running. Operate the tool only when hand-held.
6. Do not touch the drill bit or the workpiece immediately after operation; they
may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
Installing side grip (auxiliary handle)
Screw the side grip on the tool securely.
Installing or removing drill
bit
CAUTION
:
Always be sure that the tool is switched off and unplugged before installing or removing
the bit.
To install the bit, place
it
in the chuck
as
far
as it
will go. Tighten the chuck by hand.
Place the chuck key in each
of
the three
holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
Chuck
kev
4