Makita 6303 Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor Makita 6303. Makita 6303 8 halaman. 13mm (1/2") drill
Juga untuk Makita 6303: Buku Petunjuk (8 halaman), Buku Petunjuk (8 halaman)

Halaman Cetak

Drilling operation

Drilling in wood

When drilling in wood, best results are obtained with wood drills equipped with a guide

screw. The guide screw makes drilling easier by pulling the bit into the workpiece.

To prevent the bit from slipping when starting a hole, make an indentation with

center-

punch and hammer

a t

the point to be drilled. Place the point of the bit in the indenta-

tion and start drilling.

Use

cutting lubricant when drilling metals. The exceptions are iron and brass which

should be drilled dry.

Drilling in metal

CAUTION

*Pressing excessively on the tool will not speed up the drilling. In fact, this excessive

pressure will only serve to damage the tip of your bit, decrease the tool performance

and shorten the service life of the tool.

*There

is a

tremendous force exerted on the tool/bit

a t

the time of hole break through.

Hold the tool firmly and exert care when the bit begins to break through the workpiece.

*Always grip the small workpiece firmly with a

vise

or a holding means.

* A stuck bit can be removed simply by setting the reversing switch to reverse rotation

in order to back out. However, the tool will pull away easily unless you hold

firmly

before starting the tool.

MAINTENANCE

CAUTION

Always be sure that the tool

switched off and unplugged before attempting to perform

inspection or maintenance.

To maintain product SAFETY and RELlABl LITY, repairs, carbon brush inspection and

replacement, any other maintenance or adjustment should be performed by Makita

Authorized or Factory Service Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

The accessories listed in this manual are available at an extra cost from your Makita distributor or Makita factory

service center Service centers are listed on the warranty card packed with your tool

CAUTION

These accessories o r attachments are recommended f o r use w i t h y o u r Makita t o o l specified in this

manual. The use o f any other accessories or attachments m i g h t present a risk of i n j u r y t o persons. The

accessories or attachments should be used o n l y i n the proper and intended manner.

Chuck key

Part

No.

763420-6

Grip

Part No. 273406-7