Alien Aircraft Corp Hornet K-107 Manual Petunjuk Perakitan - Halaman 4

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Mainan Alien Aircraft Corp Hornet K-107. Alien Aircraft Corp Hornet K-107 17 halaman.

Alien Aircraft Corp Hornet K-107 Manual Petunjuk Perakitan

Building Instructions:

General Note: Cover the plans with wax paper before assembling your model to prevent the parts from sticking to
the plan.

Building the Tail Surfaces:

1...Glue R-1 and R-2 together. Glue R-3 and R-4 together. Sand the
outside edges round. Leave the fuselage edges square.
Bevel the front edge of R-5 as shown on the plan, and sand the other
edges round.
Mark the hinge locations and cut the hinge slots. Temporarily install
the hinges without glue.
2...Glue the S-2's to S-1. Sand one of the 1/8"x 3" dowels to 3/32"
diameter. Join the elevators (S-3) using this dowel. Use the stabilizer
as a guide. Trim the dowel if required to achieve the proper length.
Bevel the front edge of the S-3's as shown on the plan, and sand the
other edges round.
Sand the front and ends of the stabilizer round. Leave the back edge
square.
Mark the hinge locations and cut the hinge slots. Temporarily install the hinges without glue.

Building the Fuselage:

3...Glue the F-2 doublers to the inside of the F-1R & F-1L fuselage
sides. Be sure to make a right hand and a left hand side.
Note: The photos show a lightning hole in the fuselage sides (looks
like windows in the cockpit area). This has been eliminated from the
production kits. Please disreguard it in the assembly photos that fol-
low.
4...Press the four 4-40 blind nuts into the back of the firewall (F-7).
Use a small drop of thin C/A to secure them in place.
Page 4