Alien Aircraft Corp Hornet K-107 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} Alien Aircraft Corp Hornet K-107에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alien Aircraft Corp Hornet K-107 17 페이지.

Building Instructions:

General Note: Cover the plans with wax paper before assembling your model to prevent the parts from sticking to

the plan.

1...Glue R-1 and R-2 together. Glue R-3 and R-4 together. Sand the

outside edges round. Leave the fuselage edges square.

Bevel the front edge of R-5 as shown on the plan, and sand the other

edges round.

Mark the hinge locations and cut the hinge slots. Temporarily install

the hinges without glue.

2...Glue the S-2's to S-1. Sand one of the 1/8"x 3" dowels to 3/32"

diameter. Join the elevators (S-3) using this dowel. Use the stabilizer

as a guide. Trim the dowel if required to achieve the proper length.

Bevel the front edge of the S-3's as shown on the plan, and sand the

other edges round.

Sand the front and ends of the stabilizer round. Leave the back edge

square.

Mark the hinge locations and cut the hinge slots. Temporarily install the hinges without glue.

3...Glue the F-2 doublers to the inside of the F-1R & F-1L fuselage

sides. Be sure to make a right hand and a left hand side.

Note: The photos show a lightning hole in the fuselage sides (looks

like windows in the cockpit area). This has been eliminated from the

production kits. Please disreguard it in the assembly photos that fol-

low.

4...Press the four 4-40 blind nuts into the back of the firewall (F-7).

Use a small drop of thin C/A to secure them in place.

Page 4