Align Trex 700 Electric conversion Buku Petunjuk - Halaman 2
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan Align Trex 700 Electric conversion. Align Trex 700 Electric conversion 12 halaman. Nitro electronic conversion kit
Juga untuk Align Trex 700 Electric conversion: Petunjuk Pemasangan (6 halaman)
Halaman CetakRequired Items:
1. 2mm allen Wrench
2. 2.5mm allen Wrench
3. 3mm allen Wrench
4. Blue and Red locktite
5. Drill
6. Heat shrink
7. Scissors
8. 13mm open end wrench
9. Zip ties
10. Mikado 0.7 mod. 5mm pinion (recommended 20 tooth for 12s) good idea to have variety 15-20 tooth
11. 4.6mm or .18 inch drill bit (simply find a drill bit same size as the original motor mount holes existing on
the frames)
12. Industrial strength stick down velcro
13. Electric motor of choice (I recommend Neu motors for performance and reliability)
14. High Voltage Speed Controller for 12s setup ( I recommend the Castle Creation HV110 speed controller
because it simply performs outstanding under all conditions)
15. Bullet connectors for motor to speed controller connection (I recommend Venom or castle creations
connectors because they are designed for high voltage yet very affordable)
16. Deans connectors
17. Soldering Station (This is only if you need to Solder your bullet connectors to your motor and speed
controller or Dean's connector to your speed controller or batteries)
18. Servo extension (You may need a 4 inch servo extension for your speed controller to reach your receiver)