- ページ 2

おもちゃ Align Trex 700 Electric conversionのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Align Trex 700 Electric conversion 12 ページ。 Nitro electronic conversion kit
Align Trex 700 Electric conversion にも：インストール手順 (6 ページ)

ページを印刷する

Required Items:

1. 2mm allen Wrench

2. 2.5mm allen Wrench

3. 3mm allen Wrench

4. Blue and Red locktite

5. Drill

6. Heat shrink

7. Scissors

8. 13mm open end wrench

9. Zip ties

10. Mikado 0.7 mod. 5mm pinion (recommended 20 tooth for 12s) good idea to have variety 15-20 tooth

11. 4.6mm or .18 inch drill bit (simply find a drill bit same size as the original motor mount holes existing on

the frames)

12. Industrial strength stick down velcro

13. Electric motor of choice (I recommend Neu motors for performance and reliability)

14. High Voltage Speed Controller for 12s setup ( I recommend the Castle Creation HV110 speed controller

because it simply performs outstanding under all conditions)

15. Bullet connectors for motor to speed controller connection (I recommend Venom or castle creations

connectors because they are designed for high voltage yet very affordable)

16. Deans connectors

17. Soldering Station (This is only if you need to Solder your bullet connectors to your motor and speed

controller or Dean's connector to your speed controller or batteries)

18. Servo extension (You may need a 4 inch servo extension for your speed controller to reach your receiver)