Garmin GTS 8000 Mengganti - Halaman 7

Jelajahi secara online atau unduh pdf Mengganti untuk Tampilan Avionik Garmin GTS 8000. Garmin GTS 8000 16 halaman. For citation m2, garmin g3000 software version 10
Juga untuk Garmin GTS 8000: Panduan Pilot (26 halaman)

Halaman Cetak

Section 3

Aircraft Configuration

• Place the G3000 back in configuration by pressing and hold the #12 softkey on the PFD 1

and pushing in the L PFD circuit breaker. Let go when you see initializing.

• Transponder and TCAS Configuration:

o Rotate the inner right knob to go to the Aircraft Configuration page.

o Push the FMS knob to activate it.

o The cursor should be on the Aircraft Registration line. Rotating the small FMS

knob provides a single character cursor. Use the small knob to change the value,

and the large knob to move to the next character.

 U.S. registered aircraft:

 Foreign registered aircraft:

 Select the softkey labeled SET GTX1 to program #1 GTX-3000. Select OK to

 Select the softkey labeled SET GTX2 to program #2 GTX-3000. Select OK to

 Select the softkey labeled SET GTS to program the GTS-8000. Select OK to

Version 1.0

• Enter the aircraft tail number using the FMS knob to select

characters.

• The VFR code should be set to 1200.

• Press Enter.

• Note that the Hexadecimal code will need to be entered first.

• Then the tail number should be entered.

• Also the VFR code will need to be set to the correct value for the

country of registry.

• Press Enter.

acknowledge.