Garmin Reactor 40 Panduan Konfigurasi
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Peralatan Kelautan Garmin Reactor 40. Garmin Reactor 40 8 halaman. Mechanical
Juga untuk Garmin Reactor 40: Panduan Petunjuk Instalasi (11 halaman), Panduan Petunjuk Instalasi (13 halaman), Panduan Petunjuk Instalasi (29 halaman), Panduan Petunjuk Instalasi (25 halaman)
Halaman Cetak
Important Safety Information
See the Important Safety and Product Information guide in the product box for product warnings and other
important information.
To avoid possible personal injury and damage to your boat, the autopilot system should be installed by a
qualified marine installer. Specific knowledge of marine steering and electrical systems is required for proper
installation.
You are responsible for the safe and prudent operation of your vessel. The autopilot is a tool that enhances your
capability to operate your boat. It does not relieve you of the responsibility of safely operating your boat. Avoid
navigational hazards and never leave the helm unattended.
Always be prepared to promptly regain manual control of your boat.
If your motor features a kill switch, you should know how to operate it in case of an emergency. If your motor
does not feature a kill switch, you should install one before installing the autopilot system.
Learn to operate the autopilot on calm and hazard-free open water.
Use caution when operating the autopilot near hazards in the water, such as docks, pilings, and other boats.
Failure to install and maintain this equipment in accordance with these instructions could result in damage or
injury.
When in use, beware of hot surfaces on the heat-sink, motor, and solenoid components.
When in use, beware the risk of entrapment or pinching from moving parts.
Configuring the Autopilot
The autopilot system must be configured and tuned to your boat dynamics. You should use the Dockside
Wizard and the Sea Trial Wizard to configure the autopilot. These wizards walk you through the necessary
configuration steps.
If your autopilot package did not contain a helm control, you must configure the autopilot system using a
compatible chartplotter on the same NMEA 2000
configuration using either a helm control or a chartplotter.
Dockside Wizard
When performing you perform the Dockside Wizard while your boat is either in or out of the water, provide
rudder-movement clearance to avoid damage to the rudder or other objects, and use caution to avoid personal
injury that may be caused by moving parts.
You can complete the Dockside Wizard while the boat is in or out of the water.
If the boat is in the water, it must be stationary while you complete the wizard.
May 2022
REACTOR
40 KICKER
™
CONFIGURATION GUIDE
WARNING
CAUTION
network as the autopilot CCU. These instructions address
®
CAUTION
GUID-781934CB-51D4-4A33-96AE-7046C8053F80 v2