Fujitsu ABF18UI-MI Panduan Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pendingin Udara Fujitsu ABF18UI-MI. Fujitsu ABF18UI-MI 18 halaman. Floor/ceiling type

Halaman Cetak

Remote controller

Display panel

1 MODE button

2 10 °C HEAT button

3 SET TEMP. button (

4 ECONOMY button

5 SLEEP button

6 FAN button

7 START/STOP button

8 SET button (Vertical)

9 SET button (Horizontal)

0 SWING button

A TIMER MODE button

B TIMER SET (

C CLOCK ADJUST button

D RESET button

E TEST RUN button

This button is used when installing the

●

conditioner, and should not be used under

normal conditions, as it will cause the air

conditioner's thermostat function to operate

incorrectly.

●

If this button is pressed during normal op-

eration, the unit will switch to test run mode,

and the indoor unit's OPERATION indicator

lamp and TIMER indicator lamp will begin to

ﬂ ash simultaneously.

●

To stop the test run, press the START/STOP

button to stop the air conditioner.

)

) button

Display panel

To facilitate explanation, the accompanying illustration has

been drawn to show all possible indicators; in actual oper-

ation, however, the display will only show those indicators

appropriate to the current operation.

F Signal transmitter

G Temperature SET indicator

H Operating mode indicator

I SLEEP indicator

J Transmit indicator

K Fan speed indicator

L SWING indicator

M T imer mode indicator

N Clock indicator

Some indoor units may not be equipped with the functions

corresponding to all of the buttons on this remote control-

ler. The indoor unit will beep and the OPERATION, TIMER

and ECONOMY lamp ﬂ ash when a remote controller but-

ton is pressed if the function is not available.

En-5