Fujitsu ABF18UI-MI 운영 매뉴얼 - 페이지 5
{카테고리_이름} Fujitsu ABF18UI-MI에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ABF18UI-MI 18 페이지. Floor/ceiling type
페이지 인쇄Remote controller
Display panel
1 MODE button
2 10 °C HEAT button
3 SET TEMP. button (
4 ECONOMY button
5 SLEEP button
6 FAN button
7 START/STOP button
8 SET button (Vertical)
9 SET button (Horizontal)
0 SWING button
A TIMER MODE button
B TIMER SET (
C CLOCK ADJUST button
D RESET button
E TEST RUN button
This button is used when installing the
●
conditioner, and should not be used under
normal conditions, as it will cause the air
conditioner's thermostat function to operate
incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test run mode,
and the indoor unit's OPERATION indicator
lamp and TIMER indicator lamp will begin to
fl ash simultaneously.
●
To stop the test run, press the START/STOP
button to stop the air conditioner.
/
)
/
) button
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual oper-
ation, however, the display will only show those indicators
appropriate to the current operation.
F Signal transmitter
G Temperature SET indicator
H Operating mode indicator
I SLEEP indicator
J Transmit indicator
K Fan speed indicator
L SWING indicator
M T imer mode indicator
N Clock indicator
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote control-
ler. The indoor unit will beep and the OPERATION, TIMER
and ECONOMY lamp fl ash when a remote controller but-
ton is pressed if the function is not available.
En-5