AEG OKO FAVORIT 40660 i Petunjuk Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Mesin pencuci piring AEG OKO FAVORIT 40660 i. AEG OKO FAVORIT 40660 i 44 halaman. Aeg dishwasher
Juga untuk AEG OKO FAVORIT 40660 i: Informasi Pengguna (44 halaman), Petunjuk Pengguna (40 halaman), Petunjuk Pengguna (44 halaman), Petunjuk Pengguna (48 halaman)
Halaman Cetak
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for the hardness of water
3) On this setting the length of the programme may be slightly longer.
*) Factory setting
Setting the water softener
Using the table as a guide, adjust the water softener to that which cor-
responds to the hardness of the water in your area:
0
The dishwasher must be switched off.
Manual setting:
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the hardness range switch to 0
or 1 (see table).
4. Replace the lower basket.
Electronic setting:
1. Press the ON/OFF button.
The LED in the ON/OFF button will become illuminated.
If other indicators are also illuminated, this means that a programme
3
has started. The programme must be cancelled (RESET):
Press function buttons 1 and 2 simultaneously for approx. 2 seconds.
All other indicators will go out.
2. Press the function buttons 1 and 2 simultaneously and keep them
pressed until the LED indicators for function buttons 1 and 3 flash.
3. Press function button 1again.
The LED indicator for function button 1 will flash.
The multi-display will indicate the hardness setting.
4. Pressing function button 1 increases the hardness setting by 1 degree.
(Exception: hardness setting 1 follows hardness setting 10).
5. When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
Operating Instructions
11