AEG OKO FAVORIT 40660 i 사용자 지침 - 페이지 11

{카테고리_이름} AEG OKO FAVORIT 40660 i에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO FAVORIT 40660 i 44 페이지. Aeg dishwasher
AEG OKO FAVORIT 40660 i에 대해서도 마찬가지입니다: 사용자 정보 (44 페이지), 사용자 지침 (40 페이지), 사용자 지침 (44 페이지), 사용자 지침 (48 페이지)

페이지 인쇄

1) (°d) German degree, measure of the hardness of water

2) [mmol/l] millimol per litre, international unit for the hardness of water

3) On this setting the length of the programme may be slightly longer.

*) Factory setting

Setting the water softener

Using the table as a guide, adjust the water softener to that which cor-

responds to the hardness of the water in your area:

The dishwasher must be switched off.

Manual setting:

1. Open the dishwasher door.

2. Remove the lower basket from the

dishwasher.

3. Turn the hardness range switch to 0

or 1 (see table).

4. Replace the lower basket.

Electronic setting:

1. Press the ON/OFF button.

The LED in the ON/OFF button will become illuminated.

If other indicators are also illuminated, this means that a programme

has started. The programme must be cancelled (RESET):

Press function buttons 1 and 2 simultaneously for approx. 2 seconds.

All other indicators will go out.

2. Press the function buttons 1 and 2 simultaneously and keep them

pressed until the LED indicators for function buttons 1 and 3 flash.

3. Press function button 1again.

The LED indicator for function button 1 will flash.

The multi-display will indicate the hardness setting.

4. Pressing function button 1 increases the hardness setting by 1 degree.

(Exception: hardness setting 1 follows hardness setting 10).

5. When the hardness setting is correct, press the ON/OFF button.

The hardness setting is now saved.

Operating Instructions