Brother PS-9000 Panduan Pengguna - Halaman 45

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Semua dalam Satu Printer Brother PS-9000. Brother PS-9000 47 halaman. User manual
Juga untuk Brother PS-9000: Brosur & Spesifikasi (6 halaman), Panduan Pengguna (43 halaman)

Halaman Cetak
Brother PS-9000 Panduan Pengguna

PS-9000 Settings

Below are the settings for PS-9000.
General
CD-ROM
Setup
TCP/IP
CD-ROM
Setup
Receive IP
address
automatically
IP Address
44
Name
Web page
LAN Interface
AUTO
Name
Web page
DHCP/BOOTP
ENABLE
RARP
ENABLE
IP Address
0.0.0.0
Factory
Default
Set up network type. Normally use in
AUTO. If the LINK LED on the hub
does not light up after the PS-9000 is
turned on, select the appropriate
network type for the hub.
Factory
Default
Enables or disables DHCP/BOOTP.
These are protocols where the IP
address is acquired from the
DHCP/BOOTP server during start up.
In order for DHCP/BOOTP to specify
the IP address of PS-9000, a
DHCP/BOOTP server must exist
within the subnetwork and be
properly set up. PS-9000 will
automatically acknowledge DHCP
and BOOTP, and use as its own
address the IP address that it
previously received as a reply.
Enables or disables RARP. RARP is a
protocol where the IP address is
acquired from the RARP server during
start up. In order for DHCP/BOOTP to
specify the IP address of PS-9000, an
RARP server must exist within the
subnetwork and be properly set up.
Sets up the IP address of PS-9000. The
value must be configured in the
format of four series of numbers
separated by decimal points, such as
"xxx.xxx.xxx.xxx".
Explanation
Explanation