Brother PS-9000 User Manual - Page 45

Browse online or download pdf User Manual for All in One Printer Brother PS-9000. Brother PS-9000 47 pages. User manual
Also for Brother PS-9000: Brochure & Specs (6 pages), User Manual (43 pages)

Print Page

PS-9000 Settings

Below are the settings for PS-9000.

General

CD-ROM

Setup

TCP/IP

CD-ROM

Setup

Receive IP

address

automatically

IP Address

Name

Web page

LAN Interface

AUTO

Name

Web page

DHCP/BOOTP

ENABLE

RARP

ENABLE

IP Address

0.0.0.0

Factory

Default

Set up network type. Normally use in

AUTO. If the LINK LED on the hub

does not light up after the PS-9000 is

turned on, select the appropriate

network type for the hub.

Factory

Default

Enables or disables DHCP/BOOTP.

These are protocols where the IP

address is acquired from the

DHCP/BOOTP server during start up.

In order for DHCP/BOOTP to specify

the IP address of PS-9000, a

DHCP/BOOTP server must exist

within the subnetwork and be

properly set up. PS-9000 will

automatically acknowledge DHCP

and BOOTP, and use as its own

address the IP address that it

previously received as a reply.

Enables or disables RARP. RARP is a

protocol where the IP address is

acquired from the RARP server during

start up. In order for DHCP/BOOTP to

specify the IP address of PS-9000, an

RARP server must exist within the

subnetwork and be properly set up.

Sets up the IP address of PS-9000. The

value must be configured in the

format of four series of numbers

separated by decimal points, such as

"xxx.xxx.xxx.xxx".

Explanation