2N Lift8 Panduan Singkat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Singkat untuk Sistem interkom 2N Lift8. 2N Lift8 13 halaman. Io module
Juga untuk 2N Lift8: Panduan Singkat (8 halaman), Panduan Singkat (12 halaman), Panduan Singkat (14 halaman), Panduan Singkat (6 halaman), Panduan Singkat (12 halaman), Panduan Singkat (17 halaman)

Description

Typically, this audio unit is installed on lift shaft bottoms, cabin floors and roofs and/or any other

places that require communication, e.g. for lift maintenance purposes. The audio unit features an

orange robust aluminium case and is thus highly resistant against small falling objects, dripping oil

and other hardships that might occur in lift shafts. This unit is designed for outdoor applications too.

Press the ALARM button to establish connection with the control centre. The audio unit is equipped

with an integrated microphone and speaker and, thanks to its dimensions and strength, provides a

good and strong sound.

Caution - diods

Alarm call

The button is blue-backlit to indicate alarm call setup.

The button blue backlight flashes to indicate image download from a camera module.

Upgrade

The audio unit is initialised first - the ALARM button is blue-backlit.

The ALARM button blue backlight flashes to indicate an upgrading process.

The audio unit stops shining after upgrade and is ready for use.

Operation Staff

This audio unit type is operated by well-trained persons (lift maintenance staff, e.g.).

Use the ALARM button whenever a person falls into the shaft, for example.

The audio unit dials the numbers stored in the ALARM button memory – set 2 (021–026).

Caution

If set 2 (021/026) is not stored in the ALARM memory, the audio unit dials set 1

(011–016) stored in the ALARM memory.

Use the ALARM button to call the control centre or machine room audio unit configured

as an intercom.

The ALARM button is not illuminated at relax.

Before You Start

Check the product package for completeness before installation:

1 2N® Lift8 Shaft Antivandal

1 Torx 10 / Torx 20 double-ended spanner

Bushings (extra package): 1

template

1 big two-hole, sealed bushing with nut

1 replaceable big one-hole bushing seal for thick cables

1 big blank module with nut

1 small bushing with nut

1 big bushing packing

2 small bushing packings

1 bus connector

4 screws (5 × 90 mm)

4 "intelligent" mounting wall plugs (8 × 50 mm)

2N® Lift8 Shaft Antivandal

brief manual1 mounting