AEG 95751 Panduan Pengoperasian dan Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Instalasi untuk Kompor AEG 95751. AEG 95751 16 halaman. Gas hob

Building In

Fig. 8 - a

These hobs can be inserted in a built-in kitchen unit

whose depth is between 550 and 600 mm. The hobs

dimensions are shown in Fig. 8-a.

The edge of the cut out must have a minimum distance

from the rear wall of 55 mm.

If there are side walls, or sides of the furniture unit

near the hob, the cut out edges must have a minimum

distance of 150 mm.

Hanging forniture units or hoods must be placed at

650 mm. minimum from the hob.

Fitting the hob to the worktop

Before fitting the hob into the cut out, an adhesive seal

must be fitted to the underside outside edge (Fig. 8-

b) of the hob. It is essential that no gaps are left in this

seal in order to prevent spillage near the hob seeping

into the cabinet below.

1) Remove the pan supports, the burners caps and

crowns and turn the hob upside down, taking care

the ignition candles are not damaged in this

operation.

2) Place the sealing gasket all around the glass top

edge as shown in Fig. 9.

3) Fit the hob in the cut out and push it down until the

glass top and the working top come in touch, as

shown in Fig. 9.

FO 2359

FO 2518

Fig. 8-b

FO 2320

sealing gasket

Fig. 9