AEG 40809 Petunjuk Pengguna - Halaman 37

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Mesin cuci AEG 40809. AEG 40809 40 halaman.

Connect the water inlet hose to a cold water tap

with a 3/4" gas threaded orifice, after having

inserted the rugger sealing washer into the hose

collar. If the water connection is made onto new

pipes or onto pipes which have not been used for

a long time, it is advisable to run off a certain

amount of water before connecting the machine.

You can rotate the other end of the water inlet pipe at the machine end

in any direction. Unscrew the tightening ring slightly, turn the end of

the pipe as you wish and tighten the ring again firmly.

Water drainage

It is preferable to connect the drain pipe to a siphon. However, you

can put it directly in a sink or a basin, or even into a bath.

Only use original pipes as extensions (placed on the floor over a length

of not more than 3 m and at a height of not more than 1 m).

Water drained into a siphon

The end piece fitted on the end of the pipe may be

connected to any type of standard siphon.

Use a clamping collar to keep the end piece in

position on the siphon.

Water drained into a sink

When the drain pipe is placed in a sink or a wash

basin, use the elbow supplied with the washing

machine to prevent it from slipping.

This pipe could be forced out of the sink under the

pressure of the water being drained.

Small sinks should be avoided !

You can avoid this problem by fixing the elbow to

the water tap or to the wall using the orifice

provided.

Installation and connection instructions