AEG 40809 사용자 지침 - 페이지 37

{카테고리_이름} AEG 40809에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 40809 40 페이지.

AEG 40809 사용자 지침
Connect the water inlet hose to a cold water tap
with a 3/4" gas threaded orifice, after having
inserted the rugger sealing washer into the hose
collar. If the water connection is made onto new
pipes or onto pipes which have not been used for
a long time, it is advisable to run off a certain
amount of water before connecting the machine.
You can rotate the other end of the water inlet pipe at the machine end
in any direction. Unscrew the tightening ring slightly, turn the end of
the pipe as you wish and tighten the ring again firmly.
Water drainage
It is preferable to connect the drain pipe to a siphon. However, you
can put it directly in a sink or a basin, or even into a bath.
Only use original pipes as extensions (placed on the floor over a length
of not more than 3 m and at a height of not more than 1 m).
Water drained into a siphon
The end piece fitted on the end of the pipe may be
connected to any type of standard siphon.
Use a clamping collar to keep the end piece in
position on the siphon.
Water drained into a sink
When the drain pipe is placed in a sink or a wash
basin, use the elbow supplied with the washing
machine to prevent it from slipping.
This pipe could be forced out of the sink under the
pressure of the water being drained.
Small sinks should be avoided !
You can avoid this problem by fixing the elbow to
the water tap or to the wall using the orifice
provided.
Installation and connection instructions
37