Brother PT-98OOPCN Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuat label Brother PT-98OOPCN. Brother PT-98OOPCN 20 halaman. Electronic labeling system

Halaman Cetak

Installing the tape cassette

This section lists the types of tape that may be used with the printer and explains the procedures to

install the tape cassettes.

Authorized tape

The types of tape that may be used with the

printer are listed below.

■ TZ Tapes

Standard Laminated Tape

Extra Strength Adhesive Tape - Laminated

Flexible ID tape - Laminated

Tamper Evident Tape - Laminated

Fabric Iron-On Tape - Non-Laminated

■ HG Tapes

HG tapes enable three available

combinations of higher printing speed and

print resolutions. For details on high-speed

printing, refer to "Printing at a higher speed

or at a higher resolution" (→ P. 31).

Installing the tape cassette

This section explains the procedures to install

the tape cassette.

Hold down the power button on the front

of the printer, and make sure that the

power is turned off with the power

button.

Press the cover release button and open

the tape compartment cover.

Cover release button

Install the tape cassette.

Make sure that the end of the tape feeds

under the tape guides.

Toothed wheel

End of the

Tape guide

tape

• If the ink ribbon is loose, use your

finger to wind the toothed wheel in the

direction of the arrow on the cassette.

Close the tape compartment cover and

press the power button on the printer.

Press the Feed/Cut button to remove the

tape slack.

Note

●

If no additional operation is performed

within 10 minutes after printing a label,

you will hear the roller assembly being

automatically released. Prior to being

released, the tape cannot be removed

if the AC adapter is removed from the

printer with the printer powered on or if

the power is first turned off by the main

power switch on the back of the printer.

Always turn the power off first using the

power button on the front of the printer

before removing the AC adapter or

turning off the main power switch.