Fujitsu ETERNUS DX Disk Panduan Konfigurasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Server Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 35 halaman. Server connection, fcoe for linux driver settings for converged network adapter cards
Juga untuk Fujitsu ETERNUS DX Disk: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (44 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (29 halaman), Panduan Konfigurasi (25 halaman), Panduan Konfigurasi (32 halaman), Panduan Konfigurasi (31 halaman), Panduan Konfigurasi (43 halaman), Panduan Konfigurasi (21 halaman), Panduan Konfigurasi (24 halaman)

Halaman Cetak
Fujitsu ETERNUS DX Disk Panduan Konfigurasi
Chapter 1
Setup Procedure for Emulex Converged Network Adapter Cards
1.2
Setting Up the Converged Network Adapter Cards
"Boot BIOS is : Disabled" should have changed to "Boot BIOS is : Enabled".
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
01:
Mem Base:
Port Name:
Vlan ID:
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
===> Enter <Esc> to Previous Menu
5
Press the [Esc] key to return to the window shown in
6
Select "Configure Boot Devices" and press the [Enter] key.
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
01:
Mem Base:
Port Name:
Vlan ID:
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
===> Configure Boot Devices
From
Step 7
the device name for the Primary Boot device.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
Emulex OneConnect FCoE BIOS Utility, xxxxxxxx
OCexxxxx-F:
CD4C0000
Firmware Version:
xxxxxxxx xxxxxxxx
xxxx
DCBX mode:
CEE mode
Boot BIOS is: Enabled
Enter <Esc> to Previous Menu
< / > to Highlight, <Enter> to Select
Copyright (c) 1997-2009 Emulex. All rights reserved.
Emulex OneConnect FCoE BIOS Utility, xxxxxxxx
OCexxxxx-F:
CD4C0000
Firmware Version:
xxxxxxxx xxxxxxxx
xxxx
DCBX mode:
CEE mode
Enable/Disable Boot from SAN
Scan for Target Devices
Reset Adapter Default
Configure Boot Devices
Configure DCBX mode
Configure FCF CEE Parameters
Configure FCF CIN Parameters
Configure Advanced Adapter Parameters
Enter <Esc> to Previous Menu
< / > to Highlight, <Enter> to Select
Copyright (c) 1997-2009 Emulex. All rights reserved.
onwards, the examples assume that LUN00 is set and "ETERNUS DX400 series" is used as
Copyright 2015 FUJITSU LIMITED
Bus#: xx Dev#: xx Func#: xx
xxx.xxx
BIOS: Enabled!
Node Name:
xxxxxxxx xxxxxxxx
Enable
Disable
Step
3.
Bus#: xx Dev#: xx Func#: xx
xxx.xxx
BIOS: Enabled!
Node Name:
xxxxxxxx xxxxxxxx
12
®
ESX
P3AM-4772-11ENZ0