Fujitsu PRIMERGY TX300 S3 Panduan Suplemen Servis - Halaman 28
Jelajahi secara online atau unduh pdf Panduan Suplemen Servis untuk Server Fujitsu PRIMERGY TX300 S3. Fujitsu PRIMERGY TX300 S3 47 halaman.
Halaman Cetak
Replacing the intrusion switches
4.6
Replacing the intrusion switches
In the floorstand model two intrusion detection switches monitor the removing
of the left side cover and the hard disk cover. In the rack model only one
intrusion switch is active, this one monitors the removing of the top cover.
One switch is situated at the left (floorstand model) or the top (rack model) side
of the hard disk cage, the other switch at the front cover beneath the hard disk
cage. The two intrusion detection switches are serially connected on one cable
and have to be replaced in pairs.
Ê Open the server and remove the front cover or the front cover as described
in the
section "Preparation" on page
Figure 9: Removing the hood guide
Ê Push the lock of the hood guide to the right hand side using a screws driver
(1).
Ê Take out the hood guide upward.
Ê Remove the SAS/SATA backplane holder as described in
the SAS/SATA backplane" on page
28
1
Service Supplement
17.
23.
Replacement routines
section "Replacing
TX300 S3