Fujitsu ETERNUS DX Disk Panduan Konfigurasi - Halaman 21

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 43 halaman. Server connection, fcoe for linux driver settings for converged network adapter cards
Juga untuk Fujitsu ETERNUS DX Disk: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (44 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (29 halaman), Panduan Konfigurasi (25 halaman), Panduan Konfigurasi (32 halaman), Panduan Konfigurasi (35 halaman), Panduan Konfigurasi (31 halaman), Panduan Konfigurasi (21 halaman), Panduan Konfigurasi (24 halaman)

Chapter 8

Checking Connections

8.1

To turn on the connected devices, use the following procedure:

Turn on the Fibre Channel switch power (if used).

Check that the Ready LED (or equivalent) is lit on the Fibre Channel switch.

Turn on the ETERNUS AF/DX.

Check that the Ready LED is lit on the ETERNUS AF/DX.

Turn on the server.

8.2

Make the server recognize the logical units (LUN) set in the ETERNUS AF/DX storage systems.

Use the "ioscan" command to check which devices are connected.

Enter as follows for LegacyView (old format) results:

# ioscan -fn

Enter as follows for AgileView (HP-UX11iv3 and newer format) results:

# ioscan -fnN

Check that all connected devices are listed in the ioscan output and "CLAIMED" is displayed in "S/W

State".

FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for HP-UX

P3AM-3772-22ENZ0