Fujitsu Eternus DX200F Setup Manual

Jelajahi secara online atau unduh pdf Setup Manual untuk Penyimpanan Fujitsu Eternus DX200F. Fujitsu Eternus DX200F 10 halaman. Hybrid storage systems, all-flash arrays, power synchronized unit
Juga untuk Fujitsu Eternus DX200F: Panduan Pengoperasian (48 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (13 halaman), Panduan Konfigurasi (16 halaman), Panduan Konfigurasi (38 halaman), Tindakan Pencegahan Keselamatan (12 halaman)

FUJITSU Storage

ETERNUS DX200F All Flash Array

Preparation

STEP

An installation space and network environment must be prepared in advance.

Prepare the following manuals:

●

Manuals for the ETERNUS DX200F All Flash Array

●

Related manuals, such as manuals for the server or the networking equipment that is used

Installation Space

Site Planning Guide

Installation space

Check that the installation area meets the space requirements of the rack in which the ETERNUS DX200F All Flash

Array (hereafter referred to as "ETERNUS DX") is to be installed.

Environmental considerations for installation

Check if the installation area for the ETERNUS DX meets the environmental conditions and installation environment

conditions.

Power outlets

Check the type and the number of power outlets/sockets that are required to install the ETERNUS DX.

Network Environment

Configuration Guide (Basic)

•

Configuration Guide (Web GUI)

•

Completing and attaching the Network Settings label

Write down the IP address for the ETERNUS DX on the Network Settings label and attach it inside the rack.

Settings for the PC

●

Setup Network Environment

IP address : 192.168.1.2

Subnet mask : 255.255.255.0

●

Set the Web browser

Refer to "Configuration Guide (Web GUI)" for details on the settings that are required.

Setup Guide

P3AM-8482-01ENZ0