ストレージ Fujitsu Eternus DX200FのPDF セットアップマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu Eternus DX200F 10 ページ。 Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu Eternus DX200F にも: 操作マニュアル (48 ページ), 設定マニュアル (28 ページ), 設定マニュアル (13 ページ), 設定マニュアル (16 ページ), 設定マニュアル (38 ページ), 安全上のご注意 (12 ページ)
![Fujitsu Eternus DX200F セットアップマニュアル](/uploads/products/server2/2443977/2443977.jpg)
FUJITSU Storage
ETERNUS DX200F All Flash Array
Preparation
STEP
An installation space and network environment must be prepared in advance.
Prepare the following manuals:
●
Manuals for the ETERNUS DX200F All Flash Array
●
Related manuals, such as manuals for the server or the networking equipment that is used
Installation Space
Site Planning Guide
Installation space
Check that the installation area meets the space requirements of the rack in which the ETERNUS DX200F All Flash
Array (hereafter referred to as "ETERNUS DX") is to be installed.
Environmental considerations for installation
Check if the installation area for the ETERNUS DX meets the environmental conditions and installation environment
conditions.
Power outlets
Check the type and the number of power outlets/sockets that are required to install the ETERNUS DX.
Network Environment
Configuration Guide (Basic)
•
Configuration Guide (Web GUI)
•
Completing and attaching the Network Settings label
Write down the IP address for the ETERNUS DX on the Network Settings label and attach it inside the rack.
Settings for the PC
●
Setup Network Environment
-
IP address : 192.168.1.2
-
Subnet mask : 255.255.255.0
●
Set the Web browser
Refer to "Configuration Guide (Web GUI)" for details on the settings that are required.
Setup Guide
Setup Guide
P3AM-8482-01ENZ0