Fujitsu Eternus DX90 S2 Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Penyimpanan Fujitsu Eternus DX90 S2. Fujitsu Eternus DX90 S2 18 halaman. Server connection. (fibre channel) for aix
Juga untuk Fujitsu Eternus DX90 S2: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman), Instal Pengaturan (20 halaman), Konfigurasi Manual Koneksi Server (13 halaman), Instalasi Perangkat Keras (23 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (15 halaman), Panduan Konfigurasi (38 halaman)

Halaman Cetak
Fujitsu Eternus DX90 S2 Manual
Cable Connection
S T E P
Various cables need to be connected to the rear of the ETERNUS DX Disk storage system.
●
Point
●
The cables should never be bent, twisted or pulled.
IMPORTANT
LAN Cable (for Operation Management)
Connect a LAN cable (for operation management) to each MNT port.
Cable
-Installation- "4.1 LAN Cable Connection (For Operation Management)"
Host Interface Cable
Connect a Host Interface cable to each of these ports.
Cable
FC, iSCSI 10Gbit/s, FCoE
●
(for FC cable connection)
iSCSI 10Gbit/s, FCoE
●
(for Copper Twinax cable
connection)
1Gbit/s iSCSI
●
SAS
●
-Installation- "4.2 Host Interface Connection"
To help with cable management and prevent incorrect connection, attach labels to the cables and make a
note of connection origins and destinations.
This step describes dual controller type as an example. Note that there is only controller 0 (CM#0) for single
controller type.
Rear view
Rear view
1Gbit/s iSCSI
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
Controller (CM#0)
RMT port
MNT port
CA#0
CA#1
FC, iSCSI 10Gbit/s, FCoE
(for FC cable connection)
Port#0
Port#1
Port#0 Port#1
10
Controller (CM#1)
Controller enclosure
RMT port
MNT port
CA#0
CA#1
Controller enclosure
iSCSI 10Gbit/s, FCoE
(for Copper Twinax cable connection)
Port#0
Port#1
SAS
Port#0
Port#1
P3AM-4872-11EN